Info

LAYOUT FOR ROOT AND FACE BENDS LAYOUT FOR SIDE BENDS

Notes:

1. For plates between 10 mm (3/8 in.) and 20 mm (3/4 in.) thick, Customer may specify root and face bends or side bends (for pipe).

a. t s 10 mm (3/8 in.)—Two root and two face bends.

c. t between 10 mm (3/8 in.) and 20 mm (3/4 in.), customer may specify root and face or side bends.

d. Specimen geometry as described in Figures 5.7, 5.10, and 5.11.

e. For rectangular tubing, rotate bend and tensile specimens approximately 45 degrees counterclockwise from indicated location.

Figure 8.3—Ttype and Location of Bend Test Specimens for Welder Qualification, Class B Groove Welds

Was this article helpful?

0 0

Post a comment