Info

Note: For required radius, refer to Parts I and II of Section 7 through 10 for Class A through O welds, respectively. Bending fixture dimensions are for specimen radius bends on 10 mm thick specimens. If qualification welds are required on thinner material, fixture dimensions may be altered so bending radius remains as specified. T equals thickness of bend specimen.

Note: For required radius, refer to Parts I and II of Section 7 through 10 for Class A through O welds, respectively. Bending fixture dimensions are for specimen radius bends on 10 mm thick specimens. If qualification welds are required on thinner material, fixture dimensions may be altered so bending radius remains as specified. T equals thickness of bend specimen.

Figure 5.12—Bend Test Jigs

Document provided by IHS Licensee=ConocoPhillips WAN/5919206100, User=, 11/19/2003 23:12:38 MST Questions or comments about this message: please call m 07Ö45L.5 G51145Û TEB ■

AWS D3.6M :1999 QUALIFICATION

(B) ALTERNATIVE WRAPAROUND (C) ALTERNATIVE ROLLER-EQUIPPED GUIDED BEND

GUIDED BEND TEST JIG TEST JIG FOR BOTTOM EJECTION OF TEST SPECIMEN

Dimensions in inches

Bend Radius (B)

Was this article helpful?

0 0

Post a comment